![]() If you leave this value empty or blank, then the OS might automatically try to authenticate again.ĮAP type: Select the Extensible Authentication Protocol (EAP) type to authenticate secured wired connections. Enter the number of minutes to block these automatic authentication attempts, from 0-1440. To get internet access again, you have to manually remove the policy from the device.īlock period (minutes): After a failed authentication attempt, the OS automatically tries to authenticate again. The device can't connect to the internet to get an updated policy version. If the policy settings don't match your network settings, then internet access is blocked on the device. When set to Enforce, make sure your configuration settings in the policy are correct and match your network settings. When set to Do not enforce (default), the Wired AutoConfig service doesn't require using 802.1X for port authentication. If you leave this value empty or blank, then 1 attempt is used.Ĩ02.1x: When set to Enforce, the automatic configuration service for wired networks (Wired AutoConfig) requires using 802.1X for port authentication. Maximum authentication failures: Enter the maximum number of authentication failures for this set of credentials to authenticate, from 1-100. If you leave this value empty or blank, then a maximum of 3 messages are sent. Maximum EAPOL-start: Enter the number of EAPOL-Start messages, from 1 and 100. If you leave this value empty or blank, then 5 seconds are used. Start period: Enter the number of seconds to wait before sending an EAPOL-Start message, from 1-3600. If you leave this value empty or blank, then 1 second is used. If you leave this value empty or blank, then 18 seconds are used.Īuthentication retry delay period: Enter the number of seconds between a failed authentication attempt and the next authentication attempt, from 1-3600. If the device doesn't connect in the time you enter, then authentication fails. When users connect to the network, users must enter their credentials every time.Īuthentication period: Enter the number of seconds devices must wait after trying to authenticate, from 1-3600. ![]()
0 Comments
Leave a Reply. |